#I pilot remote battery indicator software#
#I pilot remote battery indicator Bluetooth#

#I pilot remote battery indicator Bluetooth#

Bluetooth i-Pilot Link Remote Replacement Options.The remote not being learned to the controller.Terrova and PowerDrive motors prior to 2017 must also be deployed, green system ready light on.) (Connected to appropriate voltage and powered on. If your Legacy i-Pilot Remote shows 'Motor Not Found' the i-Pilot Link remote is not able to communicate with the i-Pilot Link Controller built into the trolling motor. 'Motor Not Found' Error for Legacy i-Pilot Link.The remote uses a 3.7 volt, 1200mAh rechargeable Lithium battery with red connector, part number 2370712. Legacy i-Pilot Remote i-Pilot Remote will not turn on.

#I pilot remote battery indicator software#

Click on the grey button below for a walkthrough to fix the software on your i-Pilot Link Remote.īluetooth i-Pilot Link Remote 'Invalid Software' Recovery Walkthrough If upon power up of your Bluetooth i-Pilot Link remote, you see a text screen that says the current software is invalid (pictured below), this may be recoverable by updating the software from this screen.

Bluetooth i-Pilot Link Remote 'Invalid Software' Recovery.

Broken/intermittent wire in the coil cord or network plug connections.

The network plug connections, at the motor control board or in the control box, unplugged or damaged.

The remote not being paired to the controller.If your Bluetooth i-Pilot Remote shows 'Motor Not Found' the i-Pilot Link remote is not able to communicate with the i-Pilot Link Controller built into the trolling motor. 'Motor Not Found' Error for Bluetooth i-Pilot Link.To check the power level of the charge, turn the remote on and look at the battery indicator. The light only indicates the remote is connected to the charger and receiving power. The Red LED Charging light will not turn off.If the remote will not turn on and has a new battery and you are using a new charger, the remote will need to be replaced.The remote uses a charging cable, part number 2373241. The remote uses a 3.7 volt, 1200mAh rechargeable Lithium battery with white connector, part number 2390710. Ensure the pins are clean and spring back out when pushed in. The end of the remote charger cable (USB) that plugs into the remote includes two spring pins.

Use an appropriate tool to clean out any debris that may have accumulated in the charging port. You should clearly see two metallic contacts. Look inside the charging port on the bottom end of the remote.Ensure the remote charger cable (USB) end is receiving power from the AC adapter or the alternate power source being used.When plugged in, the red LED indicating the remote is connected to the charger should light up. If the remote does not turn on, charge the battery using the USB charger.To turn on the remote, quick press and release the OK button.Bluetooth i-Pilot Link Remote will not turn on.The most common issues for Bluetooth i-Pilot Link Remotes and Legacy i-Pilot Link Remotes are listed below.